Operating instructions

18
GB
Limit
setting
Limit setting
Setting for exceeding or falling below measured
values. Measurements outside of the limits are
indicated by an acoustic warning signal.
This setting can be adjusted for both measuring
modes (direct or group mode) before, during or
after a series of measurements.
Upper limit:
Alarm for exceeding limit
Lower limit:
Alarm for falling below limit
Delete
limit
Delete limits
With this setting, the previously set limits are
deleted or reset to factory settings. (high: 1250
μm, low: 0 μm)
Conrm the subsequent prompt either with
"Yes" or "No".
Limit function
6