Manual

14
Intended use
This electronic material moisture measuring device uses the capacitive meas-
uring principle and is suitable for non-destructive location and evaluation
of moisture distribution in walls, oors and ceilings. The device provides an
overview of the extent, distribution and severity of the moisture damage as
part of a building survey. It can be used in the material-independent INDEX
mode or the additional Building Material mode. Material characteristics are
available for cement screed, anhydrite screed, and concrete which can be
displayed as a CM % or mass %. This climate sensor allows the device to be
used as a hygrometer and provides other relevant parameters for analysing
the damage and moisture behaviour using the ambient temperature, humidity
and calculated dew point. The measured data can be transferred to a smart
phone via the digital connection interface.
Completely read through the operating instructions, the "Warranty and
Additional Information" booklet as well as the latest information under
the internet link at the end of these instructions. Follow the instructions
they contain. This document must be kept in a safe place and if the
laser device is passed on, this document must be passed on with it.
!
The integrated material characteristics correspond to the specified
building materials and their designation. Building materials of the same
type but with different designation / composition / strength / density
can however affect the measurement result. Furthermore, building
materials will vary from manufacturer to manufacturer due to the way
they are produced. This is why, in the event of different product
compositions or unfamiliar construction materials, a one-off
comparative moisture measurement should be taken using methods
that can be calibrated (e.g. kiln-drying method). If different measured
values occur, they should either be viewed relatively or the index mode
for moisture/drying behaviour should be used.
!
EN