Users Manual

6. Setting - Indicator

How to Set the Distance

SET 1 button : Distance -2 m

STOP button : OK

Distance setting can be set to even distance [2 / 4 / 6 / 8 / 10m] or

odd distance [1 / 3 / 5 / 7 / 9m]. The default setting is even distance.

SET 2 button : Distance +2m

: 2m or 1m

: 4m or 3m

: 6m or 5m

: 8m or 7m

: 10m or 9m

2m space per LED lamp [ ]

ON OFF

② Press & hold SET 1 button + STOP button at the same time. It is now set to odd and all values will be 1m shorter

than even setting i.e. 3m distance for PT Danger Area / 9m distance for PT Caution Area / 5m distance for VT Danger

Area / 7m distance for VT Caution Area.

※ If you want to change from odd distance to even distance again, press and hold Set 2 & STOP again.

* To change to Odd distance [1 / 3 / 5 / 7 / 9m] : Press and hold SET 1 + STOP

button at the same time.

Eg. Setting PT Danger Area 3m, PT Caution Area 9m / VT Danger Area 5m, VT Caution Area 7m

· Set an even distance 1m longer than the desired PT Danger, Caution Area / VT Danger, Caution

Area as shown below. (Set 3m⇒4m, 9m⇒10m / 5m⇒6m, 7m⇒8m)

: 4mPT Danger Area (Red LED)

: 10m

PT Caution Area (Green LED)

: 6m

: 8m

VT Danger Area (Red LED)

VT Caution Area (Green LED)

SPDS sounds warning signals by detecting proximity every 0.5 seconds, therefore

vehicle speed must be considered when setting proximity distance.

Setting

Tips