Download

USER
MANUAL
NAVCAM
-
818SHD
9
OPERATING THE NAVCAM -818SHD FOR THE FIRST TIM E
Co n n e c t a USB c a r c h a r g e r t o t h e ca r ’ s 1 2 v ( o r t r u c k s 2 4 v ) Ci g a r e t t e l i gh t e r s o c k e t a n d t h e o t h e r
end to the Micro USB port on the NAVCAM-818SHD.
Insert a Micro SD card into the Micro SD slot and turn the device on. When the ignition is turned
on, the NAVCAM-818SHD will turn on.
POWER ON/ OFF (AUTO ON/ OFF)
When connected to power, t he NAVCAM-818SHD will turn ON or OFF aut omat i cal ly w hen t he car ’ s
ignition is turned ON or OFF. If the NAVCAM-818SHD does not turn off immediately it means the
device is completing the file save process before turning off (usually only a few seconds).
To turn the NAVCAM-818SHD ON, press and hold the power but t on on t he side of t he device to
ON. To t ur n of f , pr ess and hol d t he po wer bu t t on again.
If power is “constant on” (in some European vehicles), then the NAVCAM-818SHD will need t o be
turned ON/OFF manually using the power swit ch.
ABOUT GPS SI GN A L RECEPTI ON
Fo r co n venience, your NAVCAM-818SHD will automatically connect to GPS satellites when in range.
Ju st l i k e a l l PN D ( Po r t a b l e N a v i g a t i o n D e v i c e s) t h i s m a y t a k e a f e w m i n u t e s ( e sp e c i a l l y t h e f i r st
time). The signal can also be affected by driving through tunnels for example. The GPS connection
however will reconnect when the GPS satellites come back into range.
Unt il GPS is re-connect ed, t he following feat ures may not be displayed properly:
- The navi gat i on map screen
- Dr iving speed display
- Sa f e t y a l e r t s su c h as Re d Li g h t , Sp e e d Ca m e r as, Sc h o o l Zo n e s et c.
- Tr acki ng det ai l s used by t he GPS Pl ayer such as speed, l on gi t ude, Lat i t ude and Dat e and Ti me.
Not e: Sch o o l s z o n e s b y d e f a u l t a r e se t t o 8 – 9:30am and 2:30 – 4pm 40KpH and cannot be changed
with this model.
AUTO RECORD WHEN TURNED ON
When t he NAVCAM-818SHD is turned on (via t he aut o on feature) the device will automatically
begin recording. To st op recor ding, press t he OK but t on or turn the device OFF using the power
button.
RECORDI NG FI LES
Tur n o n t he NAVCAM -818SHD. Recording should start automatically, if not press the Video Camera
button. When recording has started, a RED dot will appear on the screen (next to the timer) as well