Download

USER MANUAL DRONE-WF20
SAFETY PRECAUTIONS
Keep the battery away from heat sources such as fire and sun
Store the battery in a cool dry place
When recharging, only use the battery charger intended for that purpose
Don’t over-charge the battery
Don’t charge the battery for more than two hours
Don’t leave a charging battery unattended
Please read through the manual before use and store for later reference.
Please store small parts in a place well out of the reach of small children
Keep all body parts away from the drone while the rotor blades are spinning
Never try to repair internal circuitry. This product has no serviceable parts
Keep small parts out of reach of children as they can be a choking hazard.
Do not rush your flight. Always stay in control.
After flight, turn the DRONE off first, then turn the controller off.
Do not fly your Drone in prohibited areas, such as near airports or near/above people
Children should operate a drone only with adult supervision
Always keep sight of your drone while flying and resist the urge to fly too high
Always turn the power off on the controller and DRONE when not in use.
BATTERY PROTECTION
This DRONE is equipped with low-voltage protection. When a battery is low on charge, the programmed
control system will stop the DRONE’s rotors. The battery will then need re-charging before use
MAINTENANCE
Clean the DRONE with a clean, dry soft cloth only. To avoid irreparable damage, keep the DRONE dry
and away from water such as rain. Check the DRONE and accessories for damage before flight. If
damage is found, do not use the DRONE until it is repaired.
REMOTE CONTROL BATTERY INSTALLATION
Remove the battery cover screw using the
supplied screwdriver. Remove the battery
cover and insert 4 X 1.5V AAA batteries,
according to indicated polarity (batteries
not included). Reattach the cover and
tighten the screw.
Note: Battery installation should be done
under adult supervision. Do not mix old and new batteries inside the controller.