User's Manual

Now you must turn ON headset and then press button on headset WHILE you press TRIGGER
on gun inside the KEY PAIR menu.
*** IF using a shock bracelet, you use the same procedure and at this step, you would press the
lightning bolt button on the shock bracelet while pressing TRIGGER on the gun in the KEY PAIR
menu.
You should see +PK and then an OK message, headset should immediately connect and stop
glowing. IT is now saved. No serial number required. It will connect instantly on power up of
gun/headset. You can save 7 headset to a single gun/module. Two headset can be connected
at once. NRF52 firmware supports two concurrent device connections at high speed.
Remember to save.
*** You may need to cycle power on headset and/or gun to get the
headset to stop flashing, afterward lights should turn off.