User's Manual

ManualsBrandsLaser Tag Pro ManualsAudio EquipmentWireless Headset

Battle Company NRF52 Wireless Headset pairing procedure

Make sure the following is setup

Need beta test firmware GUN300B2.dat or above

https://drive.google.com/file/d/1prAC8dG91CIvxJvR6tYECGNmvs_dmxIX/view?usp=sharing

Turn off BT module 1 (HC-05), eventually after both modules are NRF52, then this may change.

Turn on BT module 2 (NRF52), new headset can only pair to NRF52 host modules not HC05

*Important set headset config to bluetooth module 2, so the gun knows which channel will

be the IR sensor for gameplay. You can have 2 headset per gun, and 2 shock bracelet on other

module if needed.

Enter Global Menu and Find BT2 DEVICE menu, press reload to enter

User Manual

Summary of content (5 pages)

PAGE 1
User Manual Battle Company NRF52 Wireless Headset pairing procedure Make sure the following is setup Need beta test firmware GUN300B2.dat or above https://drive.google.com/file/d/1prAC8dG91CIvxJvR6tYECGNmvs_dmxIX/view?usp=sharing Turn off BT module 1 (HC-05), eventually after both modules are NRF52, then this may change.
PAGE 2
Set Type of bluetooth to this for NRF52 modules
PAGE 3
Pairing NRF52 headset to Gen4 Gun Turn on BT module 2 (NRF52), new headset can only pair to NRF52 host modules not HC05 *Important set headset config to blutooth module 2, so the gun knows which channel will be the IR sensor for gameplay. You can have 2 headset per gun, and 2 shock bracelet on other module if needed.
PAGE 4
Now you must turn ON headset and then press button on headset WHILE you press TRIGGER on gun inside the KEY PAIR menu. *** IF using a shock bracelet, you use the same procedure and at this step, you would press the lightning bolt button on the shock bracelet while pressing TRIGGER on the gun in the KEY PAIR menu. You should see +PK and then an OK message, headset should immediately connect and stop glowing. IT is now saved. No serial number required. It will connect instantly on power up of gun/headset.
PAGE 5
If you accidentally paired a headset or want to remove all headset/bracelet etc, then press TRIGGER while in DEL PAIR menu. All headset should start to glow as they lost their whitelist connections. You can do a quick test if you wish to verify connection, enter LED1,2,3 menu and press TRIGGER. You should see a quick blink on headset. *Note, if using a shock bracelet, you can test shock functions (vibro and shock) in this menu, pairing process is same.