Installation Instructions

ManualsBrandsLaser Tag Pro ManualsElectronicsBattle Rifle Pro

Battle Company BRP/BRX pairing procedure

Zachary S. Dickerson, PE. 8/22/2019

To pair a Grenade

Be sure to have the most recent firmware installed for grenade:

https://drive.google.com/open?id=1BWsiqT3zDPlwaZGCHGbWfT_NqEu2IdKZ

Follow the instructions in the headset update video for the grenade, they are the same

procedure:

https://battlecompany.com/brx/barracks/

Now you must place the gun into bluetooth update/pairing mode. Turn on the gun and then

press and hold the RIGHT button until the music completes and you hear ‘Install Accessory’

Summary of content (6 pages)

PAGE 1
Battle Company BRP/BRX pairing procedure Zachary S. Dickerson, PE. 8/22/2019 To pair a Grenade Be sure to have the most recent firmware installed for grenade: https://drive.google.com/open?id=1BWsiqT3zDPlwaZGCHGbWfT_NqEu2IdKZ Follow the instructions in the headset update video for the grenade, they are the same procedure: https://battlecompany.com/brx/barracks/ Now you must place the gun into bluetooth update/pairing mode.
PAGE 2
Turn on your grenade, after this you must pair within 10 seconds, or it will not accept pairing request. Cycle the power on the grenade if you are not fast enough. Now, you must set the grenade down, and shoot the glowing LED with the gun. Pull the trigger on the gun. The grenade should send a long BEEP. If it did not, you need to repeat the process, or cycle the power on the grenade and shoot it during the first 10 seconds to pair.
PAGE 3
Press select button to exit pairing mode. The grenade will now only be useable by this gun in game. Point the grenade color LED at your headset and press the button on the grenade to arm it during a game. You should hear a chrip, now toss it at the enemies. It will not arm if you are dead, ran out of your 3 starting grenade uses or in a phone based game. You must be in an offline/no phone game and alive with grenade uses remaining.
PAGE 4
To Pair a NRF Headset or Shock Bracelet to the BRX Logo Check Only a BRX with the Logo on the side of the gun has the newest NRF bluetooth module Android and iOS, if there is no logo, you have the older version that is only Android compatible.
PAGE 5
Now you must place the gun into bluetooth update/pairing mode. Turn on the gun and then press and hold the RIGHT button until the music completes and you hear ‘Install Accessory **** NOTE: you must -repair your grenades if you pair a headset. Do the same procedure as above, but be sure to do all your pairing at once, as a random pairing ID number is re-generated each time you enter pairing mode.
PAGE 6
Turn on Headset, then press trigger on gun and button on headset at the same time. You should hear ‘device connected’ or ‘headset connected’. The procedure is the same for a headset and shock device. You can have 2 total devices paired at the same time (1 shock and 1 headset both running in game on the same gun at the same time, and still be able to pair to a phone).