Installation Instructions

NATURE VUE INSTALLATION INSTRUCTIONS
PULL BAR END CAP
Insert the H-Pull Bar End Cap into the end of the Pull Bar and tap in place using a
soft mallet.
7
F
G
E
A
Make sure that the long tooth on the F-Bushing and E-Brake line up with one of
the slots inside the Screen Tube. Both the E-Brake and the F-Bushing must be fully
inserted into the Screen Tube before the G-End Cap can be properly seated.
END CAP ASSEMBLY CONT.
The E-Brake, F-Bushing and G-Cassette End Cap come pre-assembled.
Slip the F-Bushing down the coiled spring to the E-Brake. On the open end of the
A-Screen Cassette, insert the E-Brake with F-Bushing into the center of the Screen
Tube, aligning the long tooth on both as noted above. Next, match up the large pin
on the top of the G-End Cap to the corresponding hole at the top of the A-Screen
Cassette Housing. Tap evenly with a soft mallet until the assembly fits snugly.
6
PAGE 4