Instruction Manual

Larson Electronics, LLC
Phone: [phone]
Fax: [phone]
www.larsonelectronics.com
4 of 10
Voltage – Load “Off”
L1 to L2 – 208 – 250 Volts
L1 to L3 – 208 – 250 Volts (Same as
L1 to L2) L2 to L3 – 0 Volts
Initial Start Up and Checking Voltage
o Turn power on to the static converter. You may hear a clicking noise from the
contactor pulling together. This is normal.
o Check Voltage
o Start load motor. The red indicator light will turn on and remain illuminated until the Off button is
pressed.
o If motor runs backwards, switch any two (2) motor leads.
o Always start machine out of gear or in lowest possible speed/gear.
o Always start the largest motor when running multiple motors.
o If motor does not start:
-Check (L1-L2) input for correct voltage.
-Static Converter may be too small or too large.
-Make sure input wire is correct size.
-Check load motor for correct wiring.
o If you hear a humming noise coming from the static converter, this is normal.
o Do not start motor more than six (6) times an hour.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The MTPC-SCHD series is designed to provide years of reliable performance. Should the need for replacement parts
arise, please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
[e-mail]
OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.