Instruction Manual

Larson Electronics, LLC
Phone: [phone]
Fax: [phone]
www.larsonelectronics.com
3 of 10
L1
L2
Single
Phase Power
(Fused or Circuit
Breaker Protected)
L1
L2
T3
Three Phase
Motor Starter
or Switch
Three Phase
Motor Load
Static Phase
Converter
L1
L2
Single
Phase Power
(Fused or Circuit
Breaker Protected)
Three Phase
T3
L2
Motor Starter
Three Phase
or Switch
Motor Load
L1
Static Phase
Converter
Idler Motor
Wiring and Connection
Wiring Method #1
o Single phase power connects through L1 and L2. T3 is the generated phase.
o Equipment with magnetic controls must operate from L1 and L2, the single phase lines. To
identify these lines, connect the two (2) single phase lines to any input terminals/lines on the
machine and press the start button. When the correct combination is found the magnets work
the motor will buzz. Try switching leads until the correct wire combination is found. Then connect
T3 to the remaining terminal/line.
Wire Method #2 (Idler Motor Method)