Instruction Manual
Table Of Contents
- WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product.
- WARNING:
- WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE INSTALLATION OR PERFORMING ANY MAINTENANCE.
- Introduction and Installation Notes
- TROUBLESHOOTING PROCEDURES
Larson Electronics, LLC
Phone: 877-348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
2 of 10
Introduction and Installation Notes
HIGH VOLTAGE – Risk of Electrical Shock. This equipment is connected to
line voltage that can create a potentially hazardous situation.
• Always make certain power is off before servicing this equipment.
• Do not connect control circuits to T3.
• Do not connect a ground or neutral to T3.
• Make sure static phase converter and equipment are properly grounded.
• Wire recommendation is based on the use of copper wire. If using aluminum wire, use the
copper equivalent for current amount.
• For indoor use.
• Humming and clicking noise is normal when power is applied to converter.
• Installation of this equipment must comply with all national, state and local electrical codes.
• Installation must be performed by qualified licensed electrician who should have
experience working with this line voltage.
Wire and Breaker/Fuse Sizing
Refer to the table on page 5.
MTPC-SCHD
Series