Installation Guide

INSPIrE INSTALLATION INSTRUCTIONS PAGE 5
4.4 SIDE LATCHING TRIPLE PANEL SCREENS
Note that this configuration uses a C-Side Profile
on one side of the opening with three A-Screen
Cassettes being installed at the opposite side
jamb. Follow step 1 and 2.1, 2.2 and 2.3 while
being certain to add additional screws when
installing the B-Top Guide Rail. Install the three
E-Recess Mount Brackets at the side jamb where
the cassettes will be placed. Locate one of the A-Screen Cassettes that does NOT have the full length magnetic seal at the
leading edge of the pull bar. This will be the first screen panel to install on the E-Recess Mount Brackets. Rotate the A-Screen
Cassette so that the open back edge aligns with the E-Recess Mount Brackets and snap the screen cassette to the brackets.
Locate the other A-Screen Cassette that does NOT have the full length magnetic seal at the leading edge of the pull bar. This
will be the second screen panel to install. Rotate the A-Screen Cassette so that the open back edge aligns with the black plastic
connection strip of the first A-Screen Cassette and snap together the screen cassettes. Take the A-Screen Cassette with the full
length magnetic seal at the leading edge of the pull bar. Position the side without the magnet so that it aligns with the second
A-Screen Cassette and snap together the screen cassettes. Continue the installation at Step 2.5 and 3.
4.3 CENTER LATCHING TRIPLE
PANEL SCREENS
Note that this configuration does not use a
C-Side Profile but instead uses three A-Screen
Cassettes with two being installed at one side
jamb and one at the opposite side jamb of the
door opening. Follow step 1 and 2.1, 2.2 and
2.3 (2.4 does not apply). Be certain to add
additional screws when installing the B-Top Guide Rail. Note that in step 2.1 you will install three E-Recess Mount Brackets
at each side jamb where cassettes will be located. For the side with only a single screen panel, locate one of the A-Screen
Cassette with the full length magnetic seal at the leading edge of the pull bar. Position the side without the magnet so that
it aligns with the three E-Recess Mount Brackets and snap into place. For the side with the double screen panels locate the
A-Screen Cassette that does NOT have the full length magnetic seal at the leading edge of the pull bar. This will be the first
screen panel to install on the E-Recess Mount Brackets. Rotate the A-Screen Cassette so that the open back edge aligns with
the E-Recess Mount Brackets and snap the screen cassette to the brackets. Take the A-Screen Cassette with the full length
magnetic seal at the leading edge of the pull bar, position the side without the magnet so that it aligns with the first A-Screen
Cassette and snap together the cassettes. Continue the installation at Step 3.
APPENDIX A cont.