Installation Guide

INSPIrE INSTALLATION INSTRUCTIONS PAGE 4

INSTALLING HANDLES (optional)

The screen comes with two metal G-Handles that can be positioned and

installed on the pull bar of the A-Screen Cassette. Locate the 3/8” wide

vertical slot down the center of the A-Screen Cassette Pull Bar. Measure up

37” from the bottom of the A-Screen Cassette and center the G-Handle

at that mark. The handle may be placed higher or lower if desired. There are

two parts for the G-Handle. Gb-Handle Base has two screw holes, with an

elevated second ﬂange. The bottom part of this piece ﬁts into the 3/8" vertical

slot on the A-Screen Cassette Pull Bar. Position as desired and attach using

H-#8 x ½”(12mm) Phillips Flathead Self-starting Screws. DO NOT

PRE-DRILL holes or you may critically damage components that are located

inside the A-Screen Cassette Pull Bar. NOTE: Make sure that the arch of

the G-Handle points toward the door end (see illustration at left).

Next, slide the Ga-Handle on to the elevated ﬂange of the Gb-Handle Base.

It will ﬁt securely over the base. There is a hex-screw pre-installed in

Ga-Handle. When properly aligned over Gb-Handle Base, tighten to

secure Ga-Handle to the A-Screen Cassette Pull Bar.

APPENDIX A

MULTIPLE SCREEN PANEL SYSTEMS

Please note that all double panel and multiple panel Inspire screens use a full length magnetic seal (rather than pile weather

strip seal at the leading edge of the A-Screen Cassette pull bar). Panels can be rotated to operate left or right.

4.1 CENTER LATCHING DOUBLE PANEL SCREENS

Note that this conﬁguration does not use a C-Side Proﬁle but instead uses two A-Screen

Cassettes with one being installed at each side jamb of the door opening. Follow the

instructions beginning at Step 1. At Step 2.1 install three E-Recess Mount Brackets at

each side jamb where the cassettes will be located. During Step 2.3 take care to add

additional screws when installing the B-Top Guide Rail.

4.2 SIDE LATCHING DOUBLE PANEL SCREENS

Note that this conﬁguration uses a C-Side Proﬁle on one side of the

opening with two A-Screen Cassettes being installed at the opposite side

jamb. Follow step 1 and 2.1, 2.2 and 2.3 while being certain to add

additional screws to when installing the B-Top Guide Rail. Locate the

A-Screen Cassette that does NOT have the full length magnetic seal at

the leading edge of the pull bar. This will be the ﬁrst screen panel to

install on the E-Recess Mount Brackets. Rotate the A-ScreenCassette so

that the open back edge aligns with the E-Recess Mount Brackets and snap the screen cassette to the brackets. Take the

A-Screen Cassette with the full length magnetic seal at the leading edge of the pull bar. Position the side without the magnet

so that it aligns with the ﬁrst A-Screen Cassette and snap together the cassettes. Continue the installation at Step 2.5 and 3.

3/8’’ Vertical

Channel

Center

Handle 37’’

from Bottom

of Pull Bar