Installation Guide

Install Top Channel

BISAGRA IZQUIERDA: Instale la manija y la placa receptora

DELE VUELTA PARA LA BISAGRA DERECHA

Parts ListTools Recommended Prep Steps

Install Window

Measure at least 1/4-in from the interior edge of the top jamb exten-

sion and mark with pencil on each side.

Center the top channel in the opening with the front edge aligned on

the marks from 1a. Mark three holes and pre-drill with a 1/8-in drill bit.

Secure the top channel with the three #8x2-in screws provided,

beginning with the side screws and installing the center screw last.

DO NOT OVERTIGHTEN.

To increase energy efficiency, seal both ends of the top channel

with silicone.

ComfortSEAL Interior Windows

INSTALLATION INSTRUCTIONS

202220938-1118

Remove top channel cover

from the top channel.

Leave sash in open

position.

Do not remove

shipping tape.

Two people are

recommended for most

installations due to the

weight of the window.

For additional

infomation on interior

windows and

installation, go to

www.LARSONdoors.com

/windows

Window Styles May Vary

Drill

Phillips Screwdriver Bit

1/8-in Drill Bit

Level

Pencil

Caulk or Silicone

1/4-in

#8x2-in Screw

Actual size

PAGE 1
Install Window ComfortSEAL Interior Windows 202220938-1118 INSTALLATION INSTRUCTIONS Tools Recommended Parts List Prep Steps Drill Phillips Screwdriver Bit 1/8-in Drill Bit Level Pencil Caulk or Silicone Remove top channel cover from the top channel. Leave sash in open position. Do not remove shipping tape. Window Styles May Vary Two people are recommended for most installations due to the weight of the window. For additional infomation on interior windows and installation, go to www.LARSONdoors.
PAGE 2
Install Corner Stops 2a Using the preinstalled hooks, hang the window on the top channel. TOP 2b Push bottom of the window unit into the opening. Use a level to ensure the unit is plumb. Use a pencil to draw a line near each corner, even with the interior surface of the window. 2d Insert the pre-cut weatherstrip sections into the slots on the back surface of the corner stops. 2c Remove window from opening to install corner stops.