Installation Guide

PAGE 8
SIDE VIEW
HEAD
OPENING HEIGHT
OUTSIDE
M-SURFACE MOUNT ‘L’ CLIP
SILL or FLOOR
MOUNTING THE SCREEN CASSETTE
Slide the M-Surface Mount ‘L’ Clips into the
top of the A-Screen Cassette.
The clips should be evenly spaced between
jambs. Make sure cassette is level and then
screw clips in place.
3
2
OPENING WIDTH
36”- 72”
73”-120”
120”-140”
140”-192”
SPRING TENSION
25
30
35
40
3
D
A
J
E
E
O
F
A
J
2A
2B
2C
INTERNAL OR
EXTERNAL OPERATION
(OPTION SET-UP
PERFORMED BY USER)
INTERNAL OPERATION
(STANDARD)
PREPARING THE SCREEN CASSETTE
Insert F-End Cap with Spring into the correct end of the A-Screen Cassette
Assembly [Fig 2A] (the assembly will only fit correctly in one end). Make sure to
line up the spring and bushing notches with one of the small slots in the center
screen tube. Wind the spring clockwise the number of turns designated in the
following chart and push the F-End Cap with Spring in place on the A-Screen
Cassette Assembly. A rubber mallet is helpful to fully seat the F-End Cap with
Spring. Note that the spring in the cassette is for tension only. You will need to
raise and lower the screen by using the G-End Cap Chain.
Remove the J-Weatherstrip from the groove at the back of the A-Screen
Cassette Assembly. This weatherstrip is not used in a surface mount
application [Fig 2A].
OPPOSITE END OF CARTRIDGE
Test Chain Guide for smooth operation. If it’s too tight, loosen allen screw. Insert
the G-End Cap with Chain into A-Screen Cassette Assembly and push into place.
The G-End Cap with Chain is setup for internal operation (operating from one
side). If desired this can be disassembled and altered to allow for either internal or
external operation [Fig 2C].
Slide one piece of the J-Weatherstrip into bottom slot of D-Pull Bar. The O-Weight
Bars are already inserted inside the hollow of the D-Pull Bar. Now insert the E-Pull
Bar End Caps into ends of D-Pull Bar [Fig 2B].
ESCAPE 800 INSTALLATION INSTRUCTIONS
SURFACE INSTALLATION