Installation Guide

ESCAPE 200 INSTALLATION INSTRUCTIONS PAGE 6
RECESS INSTALLATION
B
A
H
A
H
A
C
H
INSTALLING THE TOP AND BOTTOM GUIDE RAILS
Slide the B-Bottom Guide Rail fully onto the tab on the A-Screen Cassette
End Cap [8.1] that was installed on the door frame in Step 5.
Slide the H-Boot Body upward on this Screen Cassette until it rests snug with
the top of the door opening [8.2]. Slide the B-Bottom Guide Rail fully onto
the A-Screen Cassette End Cap [8.1] of the second cassette that is yet to be
installed within the door frame. Position the C-Top Guide Rail so that it rests
on the Pull Bar of the A-Screen Cassette Assembly that has already been
installed. Position and rest the opposite end of the C-Top Guide Rail on the pull
bar of the second A-Screen Casette Assembly. Move the second A-Screen
Cassette into the door frame and lock the second A-Screen Cassette onto
the K-Mounting Clips [5.2]. Slide the H-Boot Body upward on the second
A-Screen Cassette until it rest snug with the top of the door opening.
Position the C-Top Guide Rail onto the tab of the H-Boot Body [8.3].
8
8.1
8.2
8.3
CRIMP WEATHER STRIPS
Crimp in the upraised channel lip on the inside of each corner of the C-Top
Guide Rail and B-Bottom Guide Rail to keep the P-Pile/Weather Strip
from moving, as shown at left.
