Installation Guide

ESCAPE 200 INSTALLATION INSTRUCTIONS PAGE 5
RECESS INSTALLATION
INSTALLING THE CASSETTES
Using the M-#8 x 3/4”(19mm) Phillips Panhead Screws, install the K-Recess
Mounting Clips[5.1].
Lock one A-Screen Cassette onto the mounting clips [5.2]. The other
A-Screen Cassette will be installed in Step 8.
5
5.1 K-Clips for Recess Install
5.2 Recess Installation
Insert into clip
flange here.
Snap into clip
notch here.
VIEW FROM
ABOVE
Cassette
OPTIONAL
ACCESSORY LOCK
Identify which of the two screen panels will be the one most often used to enter
and exit the home. You will install the Slide Bolt Accessory Lock on the interior
side of this inactive panel (the side less used).
On the inactive panel loosen the Allen head set screw on the Q-Top Retainer
Guide. Slide to remove the Q-Top Retainer Guide from the interior side of the
pull bar and then reinstall it in the same groove but on the opposite side of
the pull bar (the exterior side). For now, slide the Q-Top Retainer Guide down
about 4” so it is out of the way until it is adjusted and tightened in the final step.
In this same interior groove of the pull bar, slide in an S-Slide Bolt at the
bottom and then another at the top. Make certain that the pointed end
of each Slide Bolt faces out [4.1].
4
S
S
PULL BAR
PULL BAR
TOP
BOTTOM
4.1
CUT THE TOP AND BOTTOM RAILS

SUBTRACT 5”(127mm) FROM THE TOP GUIDE
SUBTRACT 4-3/8”(111mm) FROM THE BOTTOM GUIDE
Cut the rails to size.
6