Installation Guide

ESCAPE 200 INSTALLATION INSTRUCTIONS 
TROUBLESHOOTING GUIDE
THE DOOR’S BOTTOM THRESHOLD SLOPES STEEPLY:
The Bottom Guide will not work properly installed at an angle.
Use wedge shims to adjust the Bottom Guide until level.
SCREEN IS TORN OR DAMAGED:
Replace the mesh using a Screen Refill Kit.
THE CLOSING MAGNETS DO NOT FULLY SEAL OR THE
SCREEN DOES NOT CLOSE EVENLY:
Clean the Magnets using mild soap and water.
Clean any debris from inside the Bottom Guide. Debris can
interfere with closing and smooth screen operation.
Open the screen and check that the magnet that is located in the Pull Bar
aligns with the magnetic strip in the D-Dual-Mount Side Rail with Magnet.
To alter the alignment remove the M-#8 x 3/4”(19mm) Phillips Panhead
Screws for the center of the D-Dual-Mount Side Rail. Flex the center of the
D-Dual-Mount Side Rail
then reinstall the M-#8 x 3/4”(19mm) Phillips Panhead Screws.
 
? Installation Questions ? Missing Parts ? Replacement Parts ?
DON’T GO BACK TO THE STORE!