Installation Instructions

4
Flush Sill
Sill is flush with the exterior trim.
Long/Extended Sill
Sill extends past the exterior trim.
SILL TYPE DOOR TYPE
Right/Left Inswing
Screen assembly will mount
on outside of the home.
Identify your sill and door type
Before you begin installing your new retractable screen door, it is important to
identify your sill and door type. If you have a short sill or an outswing door, you may
need to make some modifications before proceeding to the installation steps.
Short Sill
Sill stops short of the exterior trim.
Right/Left Outswing
Screen assembly will mount
on inside of the home.
Handle Modifications
If you have an outswing door
you will need to move the
lock mechanism to the inside
of the home.
NOTE: This step should be
done after the retractable
screen is installed (see pg 9).
When installing the screen
assembly make sure the
housing flange is installed onto
the door trim (or brickmold).
• A filler board is not needed
when short sills have ground
directly underneath sill.
• A filler board is needed when
short sill sits on top of a step.
• Cut the filler board and place
under the trim so the top of the
filler board is even with the sill.
Filler Board
Additional steps required
Inswing
door
Trim
Screen assembly
Jamb
Top-down view