Installation Instructions
Position the header and close the door. Use one screw to
hold the header in place. Level the header to provide an
even reveal of 1/8" across the top of the door. See Figure 3.
Install with (3) #8 x 1" Phillips pan-head screws in the
pre-drilled holes.
7 Install header.
VAULT PIN
SECURIT Y
HINGE
DOOR
STEEL
Factory drilled
5/8” hole
Vault Pin
FIGURE
4
VAUL T PIN
SECURITY
STEEL
DOOR
HINGE
FIGURE
5
Position the latch side Z-bar and mark the wood door
jamb through the lock cutout in the Z-bar. This will give
you a guide to chisel. Remove the latch side Z-bar.
Use the wood chisel to create a pocket for the latch and
deadbolt. Be careful with cuts to prevent removing excess
material. You may want to use the deadbolt as a depth
guide. The latch side Z-bar needs to cover your cutout.
8 Position latch side Z-bar.
Install the latch side Z-bar with (4) #8 x 1" Phillips pan-
head screws in the pre-drilled holes. Allow 1/8" clearance
between the Z-bar and the door.
9 Install latch side Z-bar.
#8X1” P AN HEAD SCREW
A
Detail A
1/8”
3
(Vault pins are provided and can be used for additional
security. Proceed to next step if not used.)
There are 2 pre-drilled holes on the hinge-side edge of the
door (see Figure 4). Drill a 1/8" hole through the Z-bar
and approximately 3/4" deep in the jamb.
Screw the Vault Pins provided into these holes.
This leaves approximately 3/8" of the Vault Pin exposed.
The door will close over the Vault Pins for extra security.
Be sure that the holes you drill line up with the center
of the pre-drilled holes in the door.
See Figure 5.
10Optional Vault Pins.
The pneumatic closer MUST be installed at the top
of the door. See instructions in kit for bracket installation.
12 Closer & Storm Chain Installation
The Storm Chain is to be installed at the top of the door.
Instructions are provided with the chain.
An Adjustable Expander with Rubber Sweep is provided
to give a snug t at the bottom of the door. Only one
From inside the house, adjust the Expander's height so
that the rubber seal barely touches the sill evenly across
the bottom. Drill 1/8" holes through the Expander
into the door and then fasten with #8 x l" Phillips Head
Screws. See Figure 6.
Note: Some installations may require removing and
re-setting the bottom glass
clips through the expander
sweep.
11 Adjust Expander
6
#8X1” P AN HEAD SCREW
4 202220641 920Security
sweep is used. Slide it in the track that oers the best
contact with your sill. Crimp the track to hold the sweep.