User Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
HL‐85
POWER
1. The spotlight can be plugged into a cigarette plug socket, attached directly low voltage DC
batteries, etc.
2. Each unit is configured for either 12 volts or 24 volts DC. The 12 volt models can be plugged into
12 volt DC power supplies, which most consumer vehicles operate on. The 24 volt models can be
plugged into a 24 volt DC power supply, generally for military and heavy equipment.
PLEASE NOTE: There is no difference in light output between a 12 volt and 24 volt
model. Each unit is configured to a specific voltage and IS NOT interchangeable like the
LED and HID models.
3. Power transformers (DCP-11-DP) can be purchased through our website to run this
halogen spotlight from household wall outlets.
BEAM ADJUSTMENT
 The lens/reflector assembly is threaded onto the center post. Rotating the lens/reflector causes
the beam to expand or contract. Counterclockwise rotation creates a wider flood. Clockwise
rotation creates a narrower, longer spot beam.
 The lens/reflector assembly can be removed completely to change to the red lens or while
changing the bulb.
 Additional lenses can be ordered through our website.
REPLACING THE BULB
This spotlight takes a standard H-3 bulb and can be purchased through most automotive stores, or
through our website.
(Part Number HL-8X-SB)
 Remove the lens/reflector assembly by rotating counterclockwise until fully unthreaded. Pull the
assembly out away from the light to remove.
 Unscrew the ring holding the bulb in place. The bulb will fall loose.
 Remove the 4 screws holding the top cover in place.
 Disconnect the bullet connector holding the white wire to the light.
 Pull the bulb loose from the front of the light.
 Insert new bulb, white wire first and connect the bullet connector
 Replace the top cover and 4 securing screws.
 Place flat plate of bulb into mounting hole.
 Replace chrome ring and tighten into place.
 Ensure that the bulb has seated flush against the plate and there is no gap between the chrome
ring and the shaft.