Installation Manual

Larson Electronics LLC WWW.MAGNALIGHT.COM
9419 E US HWY 75, Kemp, TX 75143 - P: 903-498-3363 F: 903-498-3364 E:
[e-mail]
2
Programmable Remote Instructions
The Golight Stryker is controlled with a programmable remote with 6561 different
channels. This feature allows you the freedom to change the channel selection, and the
receiver relearns the new selection.
Programming the Transmitter
This light has been pre-programmed at the factory, and it is not necessary to re-program
the transmitter, unless you experience outside interference.
1. IMPORTANT: Disconnect power by removing fuse or disconnecting vehicle
battery.
2. Remove battery cover from remote control.
3. Set the 7 dip switches to a selection of your choice. There are 3 positions on
each; positive, negative and neutral. Use a small screwdriver and select a position
for each dip switch. *Please note that the orientation of the +/- switch positions
may vary among different models of wireless remote controls.
4. Insert both GP 23A 12V batteries. Be sure batteries have adequate charge.
5. Replace battery cover.
a. Depress the on/off button and hold it down. Red LED will light.
b. While holding the on/off button down, reinstall the power (replace fuse or
connect vehicle battery).
c. Keep your finger on the on/off button for 5-6 seconds, and then release.
The light should now be programmed.
**Make sure all other Golights in range of the transmitter are disconnected from the
power.
Installation of Wireless Dash Control
If you have a wireless dash control, please note that it is vital for this to be attached to a
flat/smooth surface with the 4 mounting screws included. The arrow under the rubber
cover should point up.
Operation of Stryker
1. Using the remote control, turn on the light by depressing the on/off button.
2. With the 4-way arrows on the remote control, rotate your light to the desired
location. Depending upon conditions, the wireless remote may be used up to 100
feet from the Stryker.