Installation Manual

Larson Electronics LLC WWW.MAGNALIGHT.COM
9419 E US HWY 75, Kemp, TX 75143 - P: 903-498-3363 F: 903-498-3364 E:
[e-mail]
1
Permanent Mount HID Golight
Th Golight Stryker is designed to permanently attach to a vehicle. The 2-speed
Searchlight with Directional Flexibility is controlled by a wireless remote, which gives
the operator a full 370 degree horizontal rotation and a 135 degree vertical tilt with
fingertip control.
The Stryker includes
- Stryker Searchlight
- Remote Controlling Factor
- 2 GP Super Alkaline Batteries 23A 12V
- Rockguard
- Permanent Mounting Gasket
- Permanent Mounting Plate
- Mounting Screws
Mounting Instructions
Determine the location for the light on your vehicle or boat. Center the mounting plate
with the vise screw on the mounting plate to the back. Mark the hole locations for the
three mounting screws and drill a pilot hole for each with 1/8 inch bit. Fasten the
stainless steel mounting plate with 3 #10 – 16x ¾ type AB cross recessed pan head
tapping screws, stainless steel. Drill a ¼ inch hole in the center mounting plate hole to
accommodate a power cord. Install the provided grommet in the hole. Bring the power
cord through the grommet. The HID Stryker electronics are polarized. You have to
connect the positive and negative wires correctly. The 12 volt DC power wires should be
joined to the leads under the lamp with appropriate automotive wire attachments. Keep
the wire connection above the mounting surface. It is recommended that the power wire
be connected to an ignition circuit or install a separate on/off toggle switch between the
light and the power source.
Wet mounting surface with a small amount of water or lubricant for easier installation,
then place the light over the mounting plate by sliding the front of the light over the front
of the mounting plate, first pull the light backwards, then seat the back of the light on to
the mounting plate. Displace the back of the gasket and install the vise screw (provided).
Tighten the vise screw using a Phillips head screwdriver. Replace the gasket.
Each spotlight needs to be wired on a single dedicated circuit and power fused art 20
amps. With the power connected, your light is ready for operation.