Specification Sheet

Page: 2
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
The GL-30215 LED Golight Stryker from Larson Electronics produces a 2,520 lumen light beam capable of reaching over 900 feet in
distance. This 36 watt LED Golight offers a wired dash mounted remote with pan and tilt control, a magnetic mounting base, and a
housing finished in a durable black finish. This Golight is weatherproof with a weatherproof remote control and operates with 12 Volts
DC.
The GL-30215 LED Golight Stryker is designed for use in all weather conditions and produces 2,520 lumens of intense light output. These units
feature remote control operation that allows users to rotate the light 370 degrees with a hard stop and to adjust vertical tilt through 135 degrees.
Remote operation is provided by one wired dash mount remote controller that connects to the light via 20 foot harness. The remote is
constructed of polycarbonate with rubber push pad buttons for weatherproof durability. Remotes are 4 inches long by 2.5 inches wide by 1/2 inch
thick.
Click Photo to Enlarge Click Photo to Enlarge Click Photo to Enlarge
Remote Operation: Remote control functions include an on/off button, and a toggle switch which controls the up, down, left and right movement.
The light will continue movement as long as the buttons are pressed. Releasing the buttons stops movement and holds the Golight in position. A
fast and slow mode button (turtle/hare) controls the speed of the motor while the pan and tilt function buttons are depressed. Holding the button
for 12 seconds in fast mode results in a full 370 degree rotation, and 8 seconds for full tilt. Slow mode is used for pinpoint accuracy at distance
and is approximately 35 seconds for full rotation and 20 seconds for one full range of tilt.
Durability: The GL-30215 LED Golight Stryker is designed for hunting and demanding outdoor use with a weather resistant housing constructed
of high quality ASA Luran thermoplastic that is heat resistant, impact resistant, UV resistant and able to withstand rugged use and abusive
conditions. This particular Golight Stryker has a durable black finish, making it ideal for docks and buildings where an attractive appearance is
desired. Remote movement of this spotlight is provided by an automotive grade internal motor, gear, and transmission assembly that is
constructed of LEXAN, brass, and stainless steel to provide rust and corrosion resistance as well as long life and reliable operation.
Mounting: The light is magnetically mounted. The outer rubber cover of the remote can be removed so that the rear mounting plate can be
attached to a mounting surface with four screws. The remote requires that a 2 inch hole be drilled in the mounting surface to accommodate the
rear portion of the controller and wiring harness. The rear "shaft" of the mount, in combination with the base plate secures the remote. A 20 foot
harness is included. A joystick is provided to enable the operator to move the light in all directions. An on/off button and a separate fast and slow
button are positioned on the remote for ease of reach and operation.
Power: This light operates with 12 volts DC and draws 3 amps, making it ideal for vehicles, boats, ATVs, and similar sources of 12 volt direct
current. The dash mount remote is equipped with a cigarette plug for connection to a cigarette socket and the remote connects to light via 20 foot
harness (included).