Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
PROGRAMMING THE TRANSMITTER
This light has been pre-programmed at the factory, and it is not necessary to re-program the
transmitter, unless you experience outside interference.
1. IMPORTANT: Remove from base socket.
2. Remove battery cover from remote control.
3. Set the 4 dip switches to a selection of your choice. There are 2 positions on each; use a small
screwdriver and select a position for each dip switch.
4. Replace battery cover.
5. Depress the on/off button and keep it held down.
6. While holding the on/off button down, reinstall the power to the unit.
7. Keep your finger on the on/off button for 5-6 seconds, and then release. The light should now
be reprogrammed.
OPERATION OF GOLIGHT GOBEE
1. Using the remote control, turn on the light by depressing the on/off button.
2. With the 4 way arrows on the remote control, rotate your light to the desired location.
Depending on the conditions, the wireless remote may be used up to 15 feet from the Gobee.
IMPORTANT SAFETY INFORMATION
 Always follow basic safety precautions when using this product to reduce the risk of injury, fire
or electric shock.
 This light is for off-road and utility use only. It is not designed for road use as a driving light.
 The Gobee complies with Part. 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) The light and remote may not cause harmful interference, and (2) this light and
remote must accept any interference, including interference that may cause undesired
operation.
 FCC RULE Part. 15.21 – Changes or modifications made by the user not expressly approved by
Golight, Inc. for compliance could void the user’s authority to operate the equipment.
 For safe and efficient operation of your Golight, observe these guidelines:
 Using your Gobee in icing conditions could damage the gear motors.
 Your Golight is a radio transmitter and receiver operating at 433 MHZ. Whenever the
light is on, the internally mounted antenna sends out and receives radio frequency (RF)
energy.
- Modern electronic equipment, i.e. personal medical devices such as pacemakers,
hearings aids, etc. are shielded from RF energy. However, RF energy may effect
some electronic equipment.
- Vehicle electronic systems may be affected by RF energy. Check with your vehicle
manufacturer reprehensive to be sure that your Gobee will not affect the electronic
system of your vehicle.