Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
2. Feed the solar panel cable through any existing opening in the vehicle or equipment into the
battery compartment.
3. Connect the quick-disconnect plugs on the solar panel and circuit box cables. The unit is now
ready. Once the panel is exposed to sunlight, it will begin charging your battery and
preventing/removing the buildup of lead-sulfate deposits on the battery plates.
NOTE: For most effective results, we suggest you install it permanently. However, if your vehicle or
equipment does not allow for permanent installation, a temporary placement will not affect the
performance of the SBC-5.
WARNING: Because of the possibility of personal injury, always use extreme caution when working with
batteries.
WARNING: The pulsating dc current produced by this product may interfere with the correct operation
of some electronic devices when the unit is placed near the antenna. In order to ensure no interference,
the circuit box should be placed away from the antenna.
MAINTENANCE
 Be sure to keep the solar panel clean of dirt and dust so that it has optimum access to sun light.
 The circuit box has no moving parts so maintenance is unnecessary.
 Periodically check to make sure the positive and negative wires are securely fastened to the
battery terminals.