Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
Wireless Dash Control
If you have a wireless dash control, please note that it is vital for it to be attached to a flat/smooth
surface with the 4 mounting screws included. The arrow under the rubber cover should point up.
BATTERY INSTALLATION AND REMOVAL FOR TRANSMITTER
Remove battery cover: For wireless hand-held transmitter, remove Phillips head screw to remove cover.
For wireless dash mount remote, simply remove the exterior rubber cover. With battery compartment
now exposed, insert batteries according to the correct polarity or gently remove batteries by grabbing
the positive end and lifting up.
PROGRAMMABLE REMOTE INSTRUCTIONS
The Golight Stryker is controlled with a programmable remote with 2187 different channels. This feature
allows you the freedom to change the channel selection, and the receiver re-learns the new selection.
This light has been pre-programmed at the factory and is not necessary to re-program the transmitter,
unless you experience outside interference. To program transmitter:
1. IMPORTANT: Disconnect power.
2. Remove battery cover from remote control.
3. Set the 7 dip switches to a selection of your choice. There are 3 positions on each; positive,
negative and neutral. Use a small screwdriver and select a position for each dip switch. * Please
note that the orientation of the +/- switch positions may vary among different models of
wireless remote controls.
4. Insert both GP 23A 12V batteries. Be sure batteries have adequate charge.
5. Replace battery cover.
a. Depress the on/off button and hold it down. Red LED will light.
b. While holding the on/off button down, reinstall the power (replace fuse or connect
vehicle battery).
c. Keep on/off button depressed for 5-6 seconds, and then release. The light should now
be programmed.
OPERATION OF STRYKER
1. Using the remote control, turn on the light by depressing the on/off button.
2. With the joystick on the dash control, rotate your light to the desired location.
3. The speed of the light rotation can be controlled by depressing the fast/slow button one time
and by depressing it again to restore the original speed.
4. The hard wired dash control will be backlit when the bulb is illuminated.
USAGE
 This light is intended for off-road and utility use only.
 This light is intended to be mounted outside the vehicle while in use.