Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
appropriate automotive wire attachments; the red wire is the positive lead and the black wire is
the negative lead-the unit is polarity sensitive and care must be taken to observe this.
Note: Once the power is applied to the system the light will pan and tilt prior to bulb illumination. As a
safety feature, the control is backlit to indicate bulb illumination only.
Each spotlight needs to be wired on a single dedicated circuit and the power fused at 5 amps. With the
power connected, your light is ready for operation.
Wireless Dash Control
 If you have a wireless dash control, please note that it is vital for it to be attached to a
flat/smooth surface with the 4 mounting screws included.
 The arrow under the rubber cover should point up.
BATTERY INSTALLATION AND REMOVAL FOR TRANSMITTER
 Remove battery cover: For wireless hand-held transmitter, remove Phillips head screw to
remove cover. For wireless dash mount remote, simply remove the exterior rubber cover.
 With battery compartment now exposed, insert batteries according to the correct polarity or
gently remove batteries by grabbing the positive end and lifting up.
PROGRAMMABLE REMOTE INSTRUCTIONS
The Golight Stryker is controlled with a programmable remote with 2187 different channels. This feature
allows you the freedom to change the channel selection, and the receiver re-learns the new selection.
This light has been pre-programmed at the factory and is not necessary to re-program the transmitter,
unless you experience outside interference. To program transmitter:
1. IMPORTANT: Disconnect power.
2. Remove battery cover from remote control.
3. Set the 7 dip switches to a selection of your choice. There are 3 positions on each; positive,
negative and neutral. Use a small screwdriver and select a position for each dip switch. * Please
note that the orientation of the +/- switch positions may vary among different models of
wireless remote controls.
4. Insert both GP 23A 12V batteries. Be sure batteries have adequate charge.
5. Replace battery cover.
a. Depress the on/off button and hold it down. Red LED will light.
b. While holding the on/off button down, reinstall the power (replace fuse or connect
vehicle battery).
c. Keep on/off button depressed for 5-6 seconds, and then release. The light should now
be programmed.
OPERATION OF STRYKER
1. Using the remote control, turn on the light by depressing the on/off button.