Specification Sheet

Page: 2
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
Heat Management: Heat is the single largest factor in premature LED failure and color shifting. As a result, many manufacturers reduce the
output of their LEDs to reduce the amount of heat produced. These LED light bars utilize an extruded aluminum housing that incorporates an
advanced heat radiating design which dissipates heat efficiently to produce the maximum amount of power and longevity from the integrated
CREE XLamp MC-E® Emitters. The end result is more light and longer LED life with higher average lumen maintenance after 50,000 hours.
Voltage Control: These units are able to monitor and adjust input current to maintain the correct LED voltage levels regardless of input levels
across a specific range. These LED10W series LED lights can operate on current ranging from 90-264VAC @47/63 hz without any modifications
necessary as a result.
Photocell: The day/night detecting sensor that automatically turns on an flag pole LED light when the level of daylight drops. This phoocell can
detect ambient lighting and tell whether it is night or day outside. The sensor is also equipped with a test shield, allowing operators to override the
sensor to ensure its functioning properly.
Durability: The LEDP WRE series of LED light bars from Larson Electronics also offer IP68 rated construction that is designed to withstand
extremes of environmental and operating conditions. These units can withstand frigid temperatures, are waterproof to three meters and resist
ingress of dust, dirt and humidity. The housings are formed from extruded aluminum and the lenses are unbreakable polycarbonate. The CREE
XLamp® LEDs offer resistance to shocks and vibrations and are rated at 70% lumen maintenance after 50,000 hours of use.
Mounting: Suspended on top of an adjustable u-bracket, this LED light can be adjusted and tightened into any position to suit your application. A
single stud protrudes from the bottom of the u-bracket mount, enabling the operator to install the light using a simple through hole mount. In other
words, the light can be installed anywhere a 3/8" hole can be drilled.
60° Flood Beam (Stnd) 10° Wide Spot Beam (Opt)