Specification Sheet

Page: 2
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
Power: Two separate power connections are provided, including one that powers the infrared LED and one that powers the
visible LED. Thus, the visible LED can be connected to a MRAP or MATV blackout system, enabling the visible light to be
turned off when the operator goes into covert mode. One 10 watt is dedicated to visible lighting, while the other 3 watt
LED is dedicated to infrared lighting. The infrared portion of this LED light can be configured with 750Nm, 850nm or 940nm
wavelength IR LEDs.
Heat Management: Heat is the single largest factor in premature LED failure and color shifting. As a result, many
manufacturers reduce the output of their LEDs to reduce the amount of heat produced. These LED light bars utilize an
extruded aluminum housing that incorporates an advanced heat radiating design which dissipates heat efficiently to
produce the maximum amount of power and longevity from the integrated Cree XLamp® Emitters. The end result is more
light and longer LED life with higher average lumen maintenance after 50,000 hours.
Voltage Control: These units are able to monitor and adjust input current to maintain the correct LED voltage levels
regardless of input levels across a specific range. These LED10W series LED lights can operate on current ranging from 9
to 48VDC without any modifications necessary as a result. This multi-voltage capability makes these units ideal for mobile
and stand alone applications such as those found on commercial boats, heavy equipment and vehicles where power
systems don’t always operate with 12 volts and external generators, transformers or inverters are impractical.
Durability: The LED10W series of LED light bars from Larson Electronics also offer IP68 rated construction that is
designed to withstand extremes of environmental and operating conditions. These units can withstand frigid temperatures,
are waterproof to three meters and resist ingress of dust, dirt and humidity. The housings are formed from extruded
aluminum and the lenses are unbreakable polycarbonate. The Seoul Z-Power® LEDs offer resistance to shocks and
vibrations and are rated at 70% lumen maintenance after 50,000 hours of use.
Mounting: Suspended on top of adjustable u-brackets, this LED light can be adjusted and tightened into any position to
suit your application. A single stud protrudes from the bottom of each u-bracket mount, enabling the operator to install the
light using a simple through hole mount. In other words, the light can be installed anywhere a 1/4 inch hole can be drilled.
Note: Most Larson Electronics LEDLB, LEDP3W, LEDP10W, and LED10W series LED spotlights and floodlights are
terminated with a Deutsch IPD / LADD DT04-2P connector. The mating connector plug is DT06-2S. Most LEDLB,
LEDP10W and LED10W series lights ship with mating connector as part of a harness or pigtail, depending on the model.
Some larger LED lights like the LEDLB-160X2 or LEDLB-200X2 or multiple function LED lights (i.e. high/low beam,
modulating, IR/Visible combos) will have different Deutsch connectors.
LEDP10W-2S-VIR35° Flood Beam (Opt) LEDP10W-2S-VIR10° Wide Spot Beam (Stnd)