Specification Sheet

Page: 1
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
Golight Stryker (GL-3XXX) Adjustable Locking Base - GL-ALB-A-W - Aluminum Powder Coated White
Part #: GL-ALB-A-W
Adjustable locking base for Golight Stryker Remote Controlled Spotlight (GL-3XXX models). A spring loaded Pem stud snaps into one of
the numberous index holes, controlling the rotation and tilt angles. Although the angle is easy to change, no amount of vibration will
change the settings, once established. Obviously, the remote control lights can change rotation and angle, but often times the remote
control light needs to be elevated in order to have full range. Sometimes, the remote control light cannot be mounted at the very edge of
the surface or it is mounted behind some type or rail. In these cases, elevating the light 6 inches and creating new angles will improve the
performance of the light.
For people wanting to mount the Golights on an angled surface, this adjustable, locking base seems to be selling well.
It gets the Golight up about 6 inches from the mounting surface and gives them the ability to set the mount angle and
rotation at any angle they like. You just pull back on the pem studs, rotate or tilt the unit and then drop the stud into
an index hole. This makes it a snap to change the position of the base, but once it is locked into place it will stay
there no matter how much vibration. The steeper the mounting surface, the more useful this is. You can mount the
light on a 45 degree downward slope, and then use the base to bring it level. You can even mount the light facing
down and then use the base to bring it level. Thus, vertical installations are now possible with this adjustable, locking
mounting base.
This unit is made from aluminum and powder coated white. This Golight adjustable locking base was designed for marine applications.
The fasteners required to attach the removable mounting plate found on the bottom of the Golight Stryker are included for easy
installation. Simply sandwich the stainless steel mounting plate between the 2 nylon fender washers and secure the bolt through the
square hole in the top plate.
Part #: GL-ALB-A-W (835)