Specification Sheet

Page: 1
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
Waterproof Transformer Converts 120V-277V AC (wall outlet) to 12/24 Volts DC - 11 Amps Max
Part #: DCP-11
The Larson Electronics DCP-11 Waterproof Power Supply converts commonly used 100 - 277VAC electrical current to 12VDC @11
Amps. This converter is designed to be hardwired into home, boat or vehicle electrical supplies where the voltage is typically within
the 100-277VAC range and reduces it to 12VDC, allowing users to use standard AC power to operate equipment like our LED light
bars and HID Golights that require 12 Volt DC current.
The DCP-11-12V 106 watt power converter provides a safe and effective way for users to tap into and utilize common 100 to 277 Volt AC power
sources and convert this current to 12 Volts DC or 24 Volts DC for use with equipment that requires 12/24 volt electrical power. This unit can be
operated with input current ranging from 100 to 277 VAC and will output 106 watts at 11 amps on a 12 Volt DC current or 6.25 amps on a 24
Volt DC current. This power converter features an IP67 rated waterproof design, making it suitable for indoor or outdoor use and includes
integral short circuit and overload protection that will shut down the unit in case of faults and overloads to protect the unit and connected
equipment from damage.
Click Photo to Enlarge Click Photo to Enlarge
The small size and wide input voltage range of this unit make it ideal for operating Larson Electronics LED light bars, Golights and other
equipment that requires 12VDC current indoors or outdoors and anywhere 12 volt DC power is not readily available. Measuring 8.7 inches long
by 2.5 inches wide by 1.5 inches deep, this unit weighs less than one pound and is mounted with two conventional screws via slots that allow
removal and repositioning simply by loosening the screws.
This converter comes with clearly labeled input and output leads that are approximately 1 foot long and stripped and tinned for hardwired
connections using butt splice connectors, wire screws, plates, etc.