Assembly Instructions

I. Determine exactly where you want to drill a hole and mark the spot(s). Be sure that you hold the drill
perpendicular to the wall so that the anchor will sit parallel. You should drill a hole that is approximately
the same size as the plug (#M) itself. Insert plug.
II. Align one L metal (#N) to the plug and insert a large screw (#P). Secure using a Phillips screwdriver.
III. Align another L metal (#N) to the pre-drilled hole on the top panel and insert a small screw (#Q). Secure
using a Phillips screwdriver.
IV. Insert one end of the plastic line (#O) into both L metals and tighten.