Plug
Insert cam-locks (#B) into the pre-drilled holes along the sides of the right side panel (#2). Insert wood dowels and pply glue (#I) onto the wood dowels (#C). Then insert the right side panel (#2) onto the wood dowels (#C) and cam-bolts (#A). The cam-bolts will be inserted into the cam-locks (#B). Using a Phillips screw driver tighten the cam-locks until you feel resistance. Over tightening the cam-locks may break them.
I. Determine exactly where you want to drill a hole and mark the spot(s). Be sure that you hold the drill perpendicular to the wall so that the anchor will sit parallel. You should drill a hole that is approximately the same size as the plug (#M) itself. Insert plug. II. Align one L metal (#N) to the plug and insert a large screw (#P). Secure using a Phillips screwdriver. III. Align another L metal (#N) to the pre-drilled hole on the top panel and insert a small screw (#Q).
I. Align the hinges to the pre-drilled holes along the right side. Insert screws (#F) and secure using a Phillips screwdriver. II. Align the small clamps (#K) to the top and bottom sides of the glass door (#3). Insert screws (#F) and secure using a Phillips screwdriver. III. Insert handle bolt (#H) into the pre-drilled hole along the side of the glass door (#3). Insert the handle (#G) onto the other side of the bolt and secure using a Phillips screwdriver.
