Installation & Assembly

ManualsBrandsLark Manor ManualsFurnitureEnglehart 73.5'' Rolled Arm Loveseat with Reversible Cushions

 



General Sofa/Loveseat/Chair Leg Installment Guide

(Product with No Pre-drilled Holes)

 

ASSEMBLY RATING







 





O O





 





 -





 

 

Page 1 of 6

Summary of content (6 pages)

PAGE 1
Assembly Instructions General Sofa/Loveseat/Chair Leg Installment Guide (Product with No Pre-drilled Holes) (Sample image. Image may not match your particular item.) ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
PAGE 2
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST.CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in an assembly, please make sure the lock or spring washer is placed between the larger flat washer and the head of the screw or bolt. Position each part correctly and insert screws or bolts into their respective holes by hand tighten or using the proper hand tool.
PAGE 3
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. PARTS LIST HARDWARE LIST (Legs may be triangles or squares) The amount of legs and screws that have no-predilled holes to align to may vary depending on unit.
PAGE 4
I. Carefully place the seat face down onto a protected surface. II. Remove the wooden blocks from each corner of the seat. □- - --- - I / - --I ---- .... ,.Careful with', sharp nails ' \-- I I - I _, \ � ..... - - - ... I If there are no wooden blocks on each corner of the seat, then move on to step 2. ' _____ .__ Place the legs {#1} onto each corner of the seat and measure 1/4 inch on each side of the leg .
PAGE 5
I I I ; ,, ,, - - -- - '' 0----- -------- ' I I I Insert 2 screws (#A} into each leg {#1}. , X2 I ----- -� 0----------- �/ ; I : --,-/'"", ' : ' -=:- #1 #1 If using power tool. - - - - .... I �>\ \ 1 (Not included) ,✓;" '' / / / / / / / / : I ; Prepare power tool. Choose the appropriate type Phillip head for the screw. Use the power tool and align the screw perpendicular to the surface. Gently pull trigger and then accelerate until secured.
PAGE 6
If using screwdriver. I I "" - - - - .... ,; '' ' Phillips Screwdriver (not included) '' - 1 / / / / / / / / / / / / / -- \ I headthe forscrew appUse ropthe riate type Philli the screw. screwdriver and p align perpendicular to the surface. legsand onto seat the screw. Use theSecure tool powerthe by applying on theer screwdriver with screw into alignpressure the screw p pendicular to the the seat frame. This will require great force. Do no surface.