Datasheet

U.I. Lapp
GmbH
DATA SHEET
UNITRONIC BUS AS-INTERFACE (TPE)
DB2170230
valid from: 16.05.2012
Originator:
RAWE/
PDC
approved: HAPF/PDC
Document: DB2170230 page 1 of 1
All rights reserved acc. to DIN ISO 16016.
PD 0019/2.2_11.10DE
Application
Field bus cable for AS-Interface (actuator-sensor interface) networking system for the lower field area. Data transmission for
AS-Interface telegrams and power supply for AS-I slaves, master, repeater, extender and sensors is done via this un-
screened, geometrically-coded two-core flat cable. The contacting of the conductors by the insulation-displacement-system
of the AS-I modules is possible without stripping the insulation.
The oil-resistant outer sheath of this field bus cable recommends its use in typical industrial environment, especially in wet
areas of automotive industry and machining centers in combination with water-based and water-mixable cooling lubricants.
The cable is intended for flexible application and permanent installation in dry and damp interiors.
Design
Conductor
tinned
copper
,
fine
-
wire stranded
,
nom. 1.
5
mm
2
acc. to IEC 60228/VDE 0295
(class 6)
Insulation
oil resistant TPE, core

nom. 2.5 mm
Core identification code
cores
brown
and
blue
Core assembly
2
cores
parall
el
deviation, the brown core is assembled inline with the
leading
edge
Outer sheath
oil resistant TPE
,
yellow
similar to
RAL
102
1
(article number 2170230)
, black
similar to RAL 9005 (article number 2170231) or red similar to RAL 3000
(article
number 2170232)
Electrical properties at 20° C
Resistance
(
loop
)
max.
27.4
Ω/km
Insulation resistance
min.
10 G
Ωxcm
Mutual capacitance
max. 8
0 nF/km
Ind
uctance
0.5
mH/km
up to 0.75 mH/km
Characteristic impedance
70
Ω
up to 140
Ω
(at 167 kHz)
Operating voltage
ca. 30 V
(DC)
(230 V (AC) for the red version)
Operating peak vo
ltage
300
V (
not for power purposes
)
Test voltage
U
eff.
core
/
co
r
e
20
00 V
Mechanical and thermal properties
Minimum bending radius
moved: 16 mm in center line
static: 12 mm in center line
Permissible temperature range
moved
:
-
30
˚
C up to
+85
˚ C
static: -40˚ C up to +85˚ C
Halogen free
acc. to VDE 0472
-
815
General requirements
Dangerous and
forbidden substances acc. to RoHS directive
(
2002/95/EG
)
are
not allowed to the manufacturing.