User Manual

3. Run PCmover on Both PCs

Go to your New PC and follow the previous steps one and two on your New PC.

Once you see the Run PCmover on Both PCs screen on your New PC, go to step four.

Note: Do not click ‘Next’ on either PC until step four has been completed.

4. Connect Your Old and New PCs

Choose which method you will use to connect your Old and New PCs for the transfer. Laplink

recommends using a WiFi or Wired Network if available.

• WiFi or Wired Network: Both your old and new PCs must be on the same WiFi or Wired

Network. If so, your computers are already connected. Click Next on both your Old and New PCs

on the Run PCmover on Both PCs screens.

• Laplink Ethernet Cable or Laplink USB Cable: Plug the Laplink Cable into the applicable Ethernet

or USB ports on both your Old and New PCs. Click Next on both your Old and New PCs on the

Run PCmover on Both PCs screens.

Note: If the New Hardware Detected Wizard is displayed when you plug in the USB cable on

Windows XP, select “No, not this time” and click ‘Next’.