User Manual

Charging Instructions
1. Remove Go2 mains power cord from left hand storage pocket in full.
2. Plug cable into standard wall outlet to begin charging. Prevent trip hazard by ensuring mains cable and Go2 case are not placed
across walkways.
3. After charging, unplug mains power cable from wall and return cable to the left hand storage pocket in full.
* To prevent trip hazards or damage to the mains cable, always wind cable up and store it in GO² CASE cable storage pocket during
m movement or when not in use.
Transporting Instructions
1. Unplug mains power cable from wall and return cable to Go2 case left hand storage pocket in full.
2. Lift case and place over the handle of the trolley, through the trolley sleeve on the back of the Go2 case. The trolley sleeve on the
back of the Go2 Case has a snug fit, this helps the case remain stable during transport. Alternatively, tip the case on to the front
AC compartment and slide trolley through the trolley sleeve on the back of the Go2 case.
3. Extend the handle of the portable trolley and go.
Image 3
Storing Mains Cable
1. To store the mains cable, wind the cable up and place in the left hand side
lower pocket (see image 3.) and secure with velcro. Alternatively, store the looped
mains cable in the left hand side top pocket, securing and tidying the excess cable
with the cable flap.
Locking Instructions
1. Find a suitable location to secure the Go2 case to, for example the leg of a heavy desk.
2. Take the looped end of the locking cable and wrap it around the securing point and feed
lock through the looped end of the cable as shown.
3. Insert the locking device into the Go2 case lock slot located on the right hand side of the bag.
4. To lock, turn the number dials to conceal your lock combination.
5.5. To unlock, turn the number dials so the correct combination aligns with combination notching line, press do button to open.
How to set the combination of the combination cable lock?
1. The pre-set factory combination is 0-0-0-0, turn number dials so the correct combination aligns with combination notching line,
press button to open.
2. Press reset button with a small tool, do not release until the new combination is set.
3. Set new 4 digit combination by turning the number dials to align with combination notching line. Release reset button.
*When setting a new combination, ensure reset button is pressed down until new combination has been reset, releasing reset button
too early may result in an incorrect code being set. too early may result in an incorrect code being set.
How to set the combination of the combination padlock?
The preset combination is 0-0-0-0. To set your own combination, please proceed as follows:
1. Set up the dials at 0-0-0-0. Then release the shackle.
2. Turn the shackle 90°. Then press it down, while setting your own new combination.
3. Turn the shackle back to its first position. The new padlock combination is settled.