Product Manual

Seite/page 2 von/of 3
2.7. Antennas
The RFID module is intended for use with the dedicated antenna TS-AH20 only. The antenna is
connected via a dedicated SMA connector. TS-AH20 is an Inductive Loop Antenna with a loop area of
0.00032m².
2.8. Label and compliance information
The device label of the host product must be equipped with the sentence
"Contains FCC ID: 2AS5K-TSHW42 / Contains IC: 25004-TSHW42A."
The end-products will contain the following compliance statements either on the product, on the device
or both:
FCC
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
ISED
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
The IFU of the host product contains the following information:
RFID Transponder Technology
Transmit/Receive Frequency Range: 13.56 MHz ± 0.424 MHz
Transceiver class: Class I
RF Output Power: -10.83 dBµA/m at 10 m/ 32.8 ft
Type of Antenna: Inductive Loop Antenna
Antenna loop area: 0.00032 m²