4 Band Adjustable Parametric Equalizer with Subwoofer Gain Control
Table of Contents 1. Introduction 2 2. Features 3 3. Detailed Features 4 4. Installation 5 5. System 6 6. Warning 7 Introduction You have made a fine choice of a quality product. Our VBXEQ4P equalizer is a truly innovative product with: • Superb specifications for audio quality • Lots of features for versatile applications • And a nice design finish.
Features • 4 Band Adjustable Parametric Equalizer • Half Din Size • 7 Volt RMS Pre-Amp Output • Pre-amp Line Aux Inputs Via RCA & Phone Jacks • 3 Input Sources Selectable • Input Gain Adjustments • RCA AUX Input Jack • Source/Aux Input Selector • Rotary Fader • Output Volume Control • Sub Output Volume Control • Blue Light Illumination • DC 12 Volt with Remote trigger • Mounting Hardware Included • RCA Auxiliary Input (Rear) inputs for MP3, DVD, or Phone What's in the Box: • 4-Band Parametric Equalizer • 2
Detailed Features 10 11 1 12 2 3 13 4 5 14 6 7 15 8 1. Volume Control 10. DVD Gain Controls 2. Fader Control 11. Main Input 3. Main/ DVD switch 12. DVD input 4. Sub Level Control 5. Low-Pass Frequency Adjustment 6. Bass Frequency Adjustment 7. Mid-bass Frequency Adjustment 16 9 13. Front Output 14. Rear Output 15. Sub Output 8. Mid Frequency Adjustment 16. Power Plug 9. High Frequency Adjustment 17. Equalizer Frequency Controls 4 www.Lanzar.
Installation Mounting Precautions This in-dash EQ can be mounted next to the source unit or under the dash with the supplied mounting brackets. For easy set-up, mount the equalizer so the front panel controls will be easily accessible for the driver's seat after installation. In addition, observe the following precautions. 1. Check the clearance on both sides of a planned installation before drilling any holes or installing any screws. 2.
System Setup Setting System Volume After completing the system wiring, follow the steps below to properly adjust the in-dash EQ. 1. Turn the master volume control on the in-dash EQ and the amplifier gain controls to their minimum setting. 2. Turn the source unit on and increase the volume until distortion is heard, then reduce the volume just below this point. This is the maximum usable musical signal for this source unit.
Setting the Low-Pass Frequency This in-dash EQ has a built-in low-pass crossover located on the front of the unit. Set the crossover (60Hz - 90Hz) upon the type and size of your subwoofer system. 1. Plug the additional video source into the DVD input located on the back of the unit. 2. With the Main/DVD switch in the MAIN position, turn the equalizer volume to a normal listening volume. 3. With the video source in play mode, switch to the DVD input source. 4.
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@lanzar.
