User's Manual
Table Of Contents
- xPico Wi-Fi Embedded Device Server User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Configuration Using Web Manager
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Services Settings
- 7: Maintenance and Diagnostics Settings
- 8: Advanced Settings
- 9: Updating Firmware
- Appendix A: Technical Support
- Appendix B: Compliance
- Appendix C: Binary to Hexadecimal Conversions
4: Network Settings
xPico® Wi-Fi® Embedded Device Server User Guide 21
To Configure Network 2 Interface Settings
Using Web Manager
To modify network 2 WLAN interface information, click Network on the menu and select
Network 2 > Interface > Configuration.
Using XML via CLI
Include in your file: <configgroup name = "Interface" instance = "wlan0">
To View Network 2 Interface Status
Using Web Manager
In Network Interface Status, you can view both the current operational settings as well as the
settings that would take affect upon a device reboot.
To view current access piont (ap0) settings, go to Network on the menu and select Network 2
-> Interface -> Status.
Using XML via CLI
Include in your file: <statusgroup name = "Interface" instance = "wlan0">
Network 2 (wlan0) Link Status
This page shows status of a Link on the device.
To View Network 2 Link Status
Using Web Manager
To view network 2 link interface information, click Network on the menu and select Network 2
> Link > Status.
Using XML via CLI
Include in your file: <configgroup name = "Interface" instance = "wlan0">
Secondary DNS Enter the IP address of the secondary Domain Name Server.
Note: This setting will be used when Static IP is active.
Network Interface
Settings (continued)
Description
PRELIMINARY DRAFT
PRELIMINARY DRAFT