User's Manual
Table Of Contents
- xPico Wi-Fi Embedded Device Server User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Configuration Using Web Manager
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Services Settings
- 7: Maintenance and Diagnostics Settings
- 8: Advanced Settings
- 9: Updating Firmware
- Appendix A: Technical Support
- Appendix B: Compliance
- Appendix C: Binary to Hexadecimal Conversions
xPico® Wi-Fi® Embedded Device Server User Guide 14
3: Configuration Using Web Manager
This chapter describes how to configure the xPico Wi-Fi embedded device server using Web
Manager, the Lantronix browser-based configuration tool. The unit’s configuration is stored in
nonvolatile memory and is retained without power. All changes take effect immediately, unless
otherwise noted. It contains the following sections:
Accessing Web Manager
Web Manager Components
Navigating Web Manager
Accessing Web Manager
To access Web Manager, perform the following steps:
1. Open a standard web browser. Lantronix supports the latest version of Internet Explorer,
Mozilla Firefox, Safari or Chrome.
2. Enter the IP address or hostname of the xPico Wi-Fi in the address bar. The IP address may
have been assigned manually or automatically by DHCP.
3. Enter your username and password.The factory-default username is “admin” and the
password is “PASSWORD” (all capitalized). The Status web page displays product
information, network settings, line settings, and tunneling settings.
PRELIMINARY DRAFT
PRELIMINARY DRAFT