User's Manual
Table Of Contents
- xPico Wi-Fi Embedded Device Server User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Configuration Using Web Manager
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Services Settings
- 7: Maintenance and Diagnostics Settings
- 8: Advanced Settings
- 9: Updating Firmware
- Appendix A: Technical Support
- Appendix B: Compliance
- Appendix C: Binary to Hexadecimal Conversions
2: Introduction
xPico® Wi-Fi® Embedded Device Server User Guide 11
Architecture:
ARM Cortex-M3 class processor with on-chip Flash and SRAM
1MB Flash and 128KB SRAM
SPI Flash 1 MB
Power:
Input Voltage: 3.3VDC
Low power consumption of approximately 20 µA standby
Physical Interface: 40-pin Board-to-Board SMT Connector
Environmental:
Operating Temperature: –40°to +85° C
Storage Temperature : –40°to +85° C
Relative Humidity: 0% to 90% non-condensing
Certifications: FCC, IC, EU, Japan, UL, CE
Packaging:
Dimensions: 24mm (L) x 16.5mm (W) x 5.64mm (H)
Weight: 2.5g
Warranty: 5-Year Limited
Sample Applications
NEED TEXT...
Protocol Support
The xPico Wi-Fi intelligent gateway contains a full-featured IP stack. Supported protocols include:
IEEE 802.11 b/g and IEEE 802.11n (single stream) WLAN interface (2.4 GHz only)
802.11i - WPA-Personal, WPA2-Personal
Soft-AP with DHCP Server
HTTP Server
Configuration via web server (browser UI), CLI XML (Serial)
TCP/IP, UDP/IP, DHCP Server (Software enabled Access Point interface), ARP, ICMP, DHCP
Client (WLAN interface), Auto-IP, DNS
Field upgradable firmware (Over The Air - OTA)
PRELIMINARY DRAFT
PRELIMINARY DRAFT