Quick Start Guide

MOUNTING

SP500X ON HAND

Finger Strap Clip

The SP500X is equipped with a pre-installed nger strap. To correctly mount

the SP500X on your hand, you will need to install a wrist strap.

Note: There are two wrist strap sizes available for purchase seperately.

02. Secure the SP500X to the

back of the hand using the

wrist strap and nger strap.

Adjust the straps to ensure a

secure and comfortable t.

Two or three ngers may be

used based on what is most

comfortable to user.

Wrist Strap Clip

01. Install the wrist

strap by snapping the

triangle-shaped clip* onto

the clip holder as shown,

with the clip’s interior angle

pointing upwards.

*preinstalled on wrist strap

Tips:

Be careful to not over-tighten the straps.

Remove all jewelry from your wrist and hand.

Always maintain a relaxed wrist posture and low impact when printing.