Quick Start Guide

USING KEYPAD AND

LED FEEDBACK

Keypad

The LCD and keypad allow for

navigation through the SP500X

menus to retrieve data and alter

settings.

To reboot, press and hold the

green power button for ten (10)

seconds to put the SP500X into

sleep mode.

After releasing the button, press

the same button again and the

SP500X will reboot.

LED Feedback

There are two LEDs located at the back of the SP500X, on either side.

The LED colors & behavior communicate various feedback.

Firmware

Updating

R - Solid Red

*low ink, failed print,

door open, low battery

Navigate Down

Power / Enter

SP500X

Initial

Power Up,

Ready

to Print

L+R - Solid Green

System

Error*

L+R - Blinking Red

Firmware

Downloading

L+R - Blinking Green