User's Guide

Configuration via Serial Mode or Telnet Port
WiBox™ User Guide 69
Note: When configuring the HTTP or SMTP port number, take note of the
‘reserved’ port numbers on page 52.
MTU Size
The Maximum Transmission Unit (MTU) is the largest physical packet size a network
can transmit for TCP and UDP. Enter between 512 and 1400 bytes. The default
setting is 1400 bytes.
MTU Size: (1400) ? _
Ethernet Connection Type
The Product Name allows for the Ethernet speed and duplex to be manually
configured. Enter 0 for auto-negotiation (default). To select the speed and duplex,
enter one of the following: 2 (10Mbit/half duplex), 3 (10Mbit/full duplex),
4 (100Mbit/half duplex), or 5 (100Mbit/full duplex).
Ethernet connection type: (0) ? _
Configurable Server Port Number
The host attached to the WiPort may communicate with other CoBos devices on the
wireless network using the Lantronix Configuration Access Protocol (LCAP). This
service is available on server port number 0x77FE (30718) and is fixed. When the
WiPort is in bridging mode, the LCAP port number is modifiable so that the LCAP
service is available on the wired interface for WiPort configuration.
For more information on bridging, see 9:Wireless Bridging.
Config Server Port Number: (30718) ? _
Security Settings
Security settings can only be changed via the setup menu, through a Telnet or serial
connection.
Note: As recommended, set security over the dedicated network or over the
serial setup. If the parameters are set over the network (Telnet 9999),
someone else could capture these settings.
Caution: Disabling both Telnet Setup and Port 77FE prevents users
from accessing the setup menu from the network.
Disable SNMP
For security purposes, disable SNMP (if required) on the WiBox unit. The current
setting displays in parentheses.
Disable SNMP (N) ? _
SNMP Community Name
The SNMP Community Name is a required field for NMS to read or write to a device.
Enter a string of 1 to 13 characters.
SNMP Community Name (public): _