User's Guide

Configuration via Serial Mode or Telnet Port
WiBox™ User Guide 68
TCP Keepalive time in seconds
This option allows you to change how many seconds the unit waits during a silent
connection before attempting to see if the currently connected network device is still
on the network. If the unit gets no response, it drops that connection. The default
setting is 45.
TCP Keepalive time in s (1s – 65s; 0s=disable): (45)? _
ARP Cache timeout in seconds
Whenever the unit communicates with another device on the network, it adds an
entry into its ARP table. The ARP Cache timeout option allows you to define how
many seconds (1-600) the unit will wait before timing out this table. The default
setting is 600.
ARP Cache timeout in s (1s – 65s; 0s=disable): (600)? _
Enable High Performance
This option applies to Product Name-03 and later units only. It allows you to increase
the CPU performance required to use the higher baud rates on the serial interface
(460 Kbps and 920 Kbps). The standard CPU performance mode supports up to
230400 Kbps.
Enable High Performance (N)?
Notes:
 If a baud rate of 460 Kbps or 920 Kbps is set and the high performance mode is
disabled, the operation of the serial channel would be out of the specified error
tolerance, thereby leading to inconsistent speed settings on the two ends of the
serial channel.
 Increasing CPU clock speed consumes more power and generates more heat.
This reduces the maximum operating temperature specification. See the
appropriate product brief for details.
Disable Monitor Mode at bootup
This option allows you to disable all entries into Monitor Mode during startup, except
for the ‘xxx’ sequence. This prevents entry using yyy, zzz, xx1, and yy1 key
sequences (only during the bootup sequence). The default for Monitor Mode at
bootup is N (No). (See 10:Monitor Mode.)
Disable Monitor Mode @ bootup (N) ? _
HTTP Port Number
This option allows the configuration of the web server port number. The valid range is
1-65535.The default HTTP port number is 80.
HTTP Port Number : (80) ? _
SMTP Port Number
This option allows the configuration of the email port number. The valid range is
1-65535. The default SMTP port number is 25.
SMTP Port Number : (25) ? _