User's Guide

Web-Manager Configuration
WiBox™ User Guide 32
unit does not receive a response, it drops that connection.
Enter a value between 1 and 65 seconds. 0 disables
keepalive. The default setting is 45.
Monitor Mode @ Bootup
Select Disable to disable the entry into the monitor mode via
the yyy or xx1 key sequence at startup. This command
prevents the unit from entering monitor mode by interpreting
the stream of characters that are received during the device
server's initialization at startup.
CPU Performance Mode The WiBox provides a high-performance mode that supports
the baud rates 460 Kbps and 921 Kbps. When running the
serial port at 460 Kbps or 921Kbps, the CPU must be placed
in the high performance mode to keep the serial port within
this baud rate specification. The maximum serial speed when
not in high performance mode is 230 Kbps. The default is
Low.
FROM COBOS MASTER
Select the WiBox’s performance mode. Higher performance
settings require more energy. Regular is 48 Mhz; High is 88
Mhz. The default setting is Regular.
HTTP Server Port This option allows the configuration of the web server port
number. The valid range is 1-65535. The default HTTP server
port number is 80.
MTU Size? DOES WIBOX
HAVE THIS?
3. When you are finished, click the OK button.
4. On the main menu, click Apply Settings.
Hostlist Configuration
The hostlist operates in a sequential order when attempting to connect to the first
available host. The WiBox scrolls through the hostlist until it connects to a device
listed in the hostlist table. After a successful connection, the unit stops trying to
connect to any others. If this connection fails, the unit continues to scroll through the
table until the next successful connection.
The hostlist supports a minimum of 1 and a maximum of 12 entries. Each entry
contains an IP address and a port number.
Note: The hostlist is disabled for Manual and Modem Mode. The unit will not
accept a data connection from a remote device when the hostlist option is
enabled.
To configure the WiBox’s hostlist:
1. From the main menu, click the Hostlist tab.