User's Manual
Table Of Contents
- Labeling of the End Product
- Integration Note
- Using This Guide
- Introduction
- Configuration Using DeviceInstaller
- Server Configuration
- WLAN Configuration
- Host List Configuration
- OEM Pin Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- Accessing WiPort using Web-Manager
- Host List Configuration
- Channel 1 and Channel 2 Configuration
- Email Configuration
- WLAN Configuration
- OEM Pin Configuration
- Updating Settings
- Configuration via Serial Mode or Telnet Port
- Configurable Pins
- Monitor Mode
- Updating Firmware
- Troubleshooting
WiPort™ User Guide 71
9
9
:
:
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
This chapter discusses how you can diagnose and fix errors quickly without having to
contact a dealer or Lantronix. The WiPort’s diagnostic LEDs indicate the unit’s
status. It helps to connect a terminal to the serial port while diagnosing an error to
view summary messages that may be displayed. When troubleshooting, always
ensure that the physical connections (power cable, network cable, and serial cable)
are secure.
Note: Some unexplained errors might be caused by duplicate IP addresses on the
network. Make sure that your unit's IP address is unique.
When troubleshooting the following problems, make sure that the WiPort is powered
up. Confirm that you are using a good network connection.
Diagnostic LED States
Condition Diagnostic LED Channel 1 Status LED
No Errors OFF N/A
Firmware storage checksum
error
ON Blink 1x/4 seconds
RAM error ON Blink 2x/4 seconds
Network controller error ON Blink 3x/4 seconds
Serial number storage
checksum error
ON Blink 4x/4 seconds
Duplicate IP address present ON Blink 5x/4 seconds
Firmware and hardware
mismatch
ON Blink 6x/4 seconds
Faulty network connection Blink 2x/second Blink 4x/4 seconds
No DHCP response Blink 2x/second Blink 5x/4 seconds
Setup menu active Blink 2x/second
Follow Diagnostic LED for 2
seconds, off for 2 seconds